Wire EDM Features
-
Multipass facility (Up to 60-70mm height in punch and up to 100 – 120mm height in cavity)
-
Controller with Industrial P.C. (Chassis) and works on WINDOWS 7 platform. Inbuilt NCCAD software.
-
L.M. Guide ways for X & Y axis
-
Pitch accuracy 0.02mm and dimensional accuracy ±0.01mm, Circularity is within 0.02mm
-
Job taper – less than ±0.020mm for a height of 450mm
-
Can cut a minimum radius of 0.08mm
-
Total connected power of the Machine is 1.5KVA
-
Low running cost
-
Paper filter not required. Reusable fine magnetic filtering system provided
-
Can cut up to 600mm height.
-
No bow in the job because of higher wire tension, wire stiffness and low-pressure coolant.
-
Reusable molybdenum wire technology (can cut area min. up to 60,000 Sq. mm. for 350-meter length of wire at appropriate parameter setting).
-
Can read DXF files. Simple programming
-
Soft water and soap Gel is mixed and used as a coolant, which gives a good surface finish, anti corrosive protection to the components as well as machine.
-
No specific foundation is required.
-
Easy maintenance
-
Can obtain a surface finish of 1.25 µRa in multipass machine. (under appropriate parameter setting and standard test conditions)
-
Air conditioning is not required(working temperature range is between 0–40°C)
-
New programs can be entered while cutting previous program
-
Auto centre find, auto edge find, auto shut off at wire breakage and auto stop at the end of job.